Philadelphia Tap Water: What’s in It and the Best Filter

Disclosure: we may earn a commission from links on this page, at no cost to you. How we choose filters.

Philadelphia Tap Water: What's in It and the Best Filter: illustration of a city skyline with a water drop

Short answer: Philadelphia tap water met every federal and state drinking water standard in the Philadelphia Water Department’s 2025 report, with no violations listed. The parts worth a closer look are PFAS (PFOA and PFOS were found at a few parts per trillion), lead from older home plumbing, and moderately hard water in neighborhoods served by the Schuylkill River plants.

Key takeaways

  • Philadelphia tap water comes from two rivers, the Delaware and the Schuylkill, and is treated at three plants before it reaches your faucet.
  • The city disinfects with chloramine, so a carbon filter certified for chloramine reduction is the fix if the taste bothers you.
  • The highest PFOA result (6.1 ppt) sits above the 4 ppt federal limit that utilities do not yet have to meet, so a PFAS-certified filter is a reasonable precaution.
  • Hardness ranges from about 6 to 10 grains per gallon on average depending on which plant serves your block.

Where does Philadelphia tap water come from?

The Philadelphia Water Department (PWD) draws all of its drinking water from rivers rather than wells. The Baxter plant in the Northeast pulls from the Delaware River. The Queen Lane and Belmont plants pull from the Schuylkill River and mainly serve the western, central and northwestern parts of the city. Some areas get a blend, so your exact water depends on your address.

At each plant, river water is settled, filtered and disinfected. PWD reported that all three plants met the turbidity (cloudiness) requirement every time in 2025 and had no quarters out of compliance for organic carbon removal. For disinfection in the pipes, the department adds chlorine together with ammonia to form chloramine. Monthly averages of disinfectant in the distribution system ran from 1.54 to 2.54 ppm, under the 4.0 ppm ceiling.

Because chloramine lasts longer in pipes than plain chlorine, it is harder to remove with a basic pitcher. If you notice a pool-like smell, look for a filter whose certification specifically lists chloramine.

Philadelphia water hardness

Hardness in Philadelphia depends on the river. The 2025 report lists these averages:

Treatment plant Source Average hardness Range
Baxter Delaware River 101 ppm (6 gpg) 72–121 ppm (4–7 gpg)
Belmont Schuylkill River 151 ppm (9 gpg) 99–204 ppm (6–12 gpg)
Queen Lane Schuylkill River 169 ppm (10 gpg) 119–270 ppm (7–16 gpg)

On the common scale, 3.5 to 7 grains per gallon counts as moderately hard and 7 to 10.5 as hard. Northeast Philadelphia homes on Delaware water get moderately hard water, which leaves some spotting but rarely causes big problems. Homes fed by Queen Lane or Belmont see hard water, which builds scale faster in water heaters, shower heads and dishwashers.

A full water softener is optional here. It mostly makes sense if you are on Schuylkill water, have a tankless water heater, or are tired of descaling fixtures. Keep in mind that a softener does not remove PFAS, lead or chloramine, so it solves a different problem than a filter. Our guide to whole-house filters covers systems that pair carbon filtration with scale control.

What PWD detected in 2025

Below are the regulated substances PWD found in treated water. None exceeded its legal limit. ppm = parts per million, ppb = parts per billion, ppt = parts per trillion.

Contaminant Highest level Legal limit (MCL) Health goal (MCLG) Typical source
Nitrate 5.3 ppm 10 ppm 10 ppm Fertilizer runoff, septic systems
Fluoride 0.75 ppm 2 ppm (state) 2 ppm Added for dental health; natural deposits
Barium 0.043 ppm 2 ppm 2 ppm Drilling waste, natural deposits
Antimony 0.0007 ppm 0.006 ppm 0.006 ppm Refineries, fire retardants, solder
Chromium 2 ppb 100 ppb 100 ppb Steel and pulp mills, natural deposits
Alpha emitters (2023 test) 5.32 pCi/L 15 pCi/L 0 pCi/L Erosion of natural deposits
Total trihalomethanes 51 ppb (running annual average) 80 ppb none set Byproduct of disinfection
Haloacetic acids (HAA5) 41 ppb (running annual average) 60 ppb none set Byproduct of disinfection
PFOA 6.1 ppt 14 ppt state; 4 ppt federal (not yet in force) 8 ppt state; 0 ppt federal Industrial and consumer products
PFOS 4.6 ppt 18 ppt state; 4 ppt federal (not yet in force) 14 ppt state; 0 ppt federal Industrial and consumer products

The disinfection byproducts are averaged over a year; single samples ranged higher (up to 90 ppb for trihalomethanes and 86 ppb for HAA5). PFAS results met Pennsylvania’s current limits. Other PFAS that PWD tracked, including PFNA, PFHxS and PFBS, were found at low single-digit parts per trillion, and GenX was not detected.

Lead and copper in Philadelphia

Lead is not in the river water. It comes from lead service lines, old solder and some brass fixtures inside buildings. PWD’s report lists results from 106 homes:

  • Lead: 90th percentile 2.0 ppb, against an action level of 15 ppb. One home of 106 was above 15 ppb, and the highest single result was 21 ppb.
  • Copper: 90th percentile 0.210 ppm, against an action level of 1.3 ppm. No homes were above it.

A low citywide number does not tell you about your own pipes. If your house was built before the late 1980s, check your service line material and consider a filter certified for lead. PWD offers zero-interest loans through its Homeowner Emergency Loan Program (HELP) for replacing a lead or galvanized service line.

Violations

None reported. PWD lists no violations for any monitored substance in its 2025 report.

Do you need a filter in Philadelphia?

Match the filter to the concern you actually have:

  • Chloramine taste or smell: a carbon filter certified for chloramine reduction. For every tap, a whole-house system built for chloraminated city water; for just drinking water, an under-sink unit.
  • PFAS and lead: a reverse osmosis system or a carbon filter certified to NSF/ANSI 53 or 58 for PFOA/PFOS and lead. This is the most useful upgrade for Philadelphia’s numbers.
  • Budget option: a certified pitcher that lists lead and PFOA/PFOS reduction, if you change the cartridge on schedule.
  • Scale from hard water: a softener or scale-control system, mainly for homes on Schuylkill water.

You do not need a well water system unless your home has its own private well, which is rare inside city limits.

FAQ

Is Philadelphia tap water safe to drink?

Philadelphia tap water met all federal and state drinking water standards in the Philadelphia Water Department’s 2025 report, which lists no violations. Lead depends on your home’s plumbing, and PFOA and PFOS were found at a few parts per trillion, so a filter certified for lead and PFAS is a reasonable choice if those concern you.

Is Philadelphia water hard or soft?

It is moderately hard to hard. Average hardness was 6 grains per gallon at the Delaware River plant and 9 to 10 grains per gallon at the two Schuylkill River plants in the 2025 report.

Does Philadelphia use chlorine or chloramine?

Chloramine. PWD adds chlorine and ammonia together, which keeps disinfectant active through the city’s long pipe network. Pick a filter certified for chloramine if you want to reduce the taste.

Where does Philadelphia get its water?

From two rivers. The Baxter plant treats Delaware River water for Northeast Philadelphia, while the Queen Lane and Belmont plants treat Schuylkill River water for the western, central and northwestern parts of the city. Some neighborhoods get a blend, so your water depends on your address.

Sources: Philadelphia Water Department, 2025 Drinking Water Quality Report and PWD Drinking Water Quality page. Values change every year; the figures on this page come from the utility’s 2025 report.