San Antonio Tap Water: What’s in It and the Best Filter

Disclosure: we may earn a commission from links on this page, at no cost to you. How we choose filters.

San Antonio Tap Water: What's in It and the Best Filter: illustration of a city skyline with a water drop

Short answer: San Antonio tap water from SAWS met federal and state standards in 2025, and the utility reports no violations for the year. The two things most San Antonio households notice are very hard water and a disinfection byproduct level worth a closer look, so a carbon filter for drinking water and a softener for the whole house are the upgrades that pay off most often.

This guide to San Antonio tap water is built from the San Antonio Water System (SAWS) 2026 Water Quality Report, which covers testing done in 2025. Figures shift from year to year, so treat the numbers below as a snapshot of that report rather than a permanent rating.

Key takeaways

  • SAWS reports zero violations in 2025, and its lead 90th percentile was 1.6 ppb (2024 sampling), with no homes over the action level.
  • The water is very hard: SAWS puts typical hardness at 15 to 20 grains per gallon, enough to leave heavy scale on fixtures and inside water heaters.
  • Total trihalomethanes (TTHMs), a chlorine byproduct, show a highest average of 86.2 ppb against an 80 ppb limit in the report table, which SAWS marks as not a violation. A carbon filter is a sensible hedge.
  • The 2026 report contains no PFAS results, so if PFAS matter to you, a certified reverse osmosis system is the cautious choice.

Where San Antonio water comes from

Unlike most big Texas cities, San Antonio leans heavily on groundwater. SAWS draws from the Edwards, Carrizo, Simsboro, Trinity and Wilcox aquifers, and some areas also receive treated surface water from Canyon Lake. The utility supplements its own wells with purchased water from several regional suppliers, including the Vista Ridge pipeline, Canyon Regional Water Authority, GBRA Western Canyon and the Schertz Seguin Local Government Corporation. Which blend reaches your faucet depends on your neighborhood.

Disinfection uses free chlorine. In 2025 the chlorine residual averaged 1.46 ppm, with readings from 0.16 to 3.7 ppm, all under the 4 ppm maximum. Free chlorine is easy to taste and smell, but it is also one of the simplest things for an activated carbon filter to reduce.

SAWS is the main utility for the city, but a few outlying neighborhoods and suburbs get water from other providers. Check the name on your water bill before relying on these numbers.

San Antonio water hardness

According to SAWS, the hardness of the water it delivers typically runs 15 to 20 grains per gallon (gpg). Converted, that is roughly 257 to 342 mg/L as calcium carbonate. Anything above about 10.5 gpg is usually classed as very hard, so San Antonio sits well past that line. That is the natural result of water that has spent a long time in limestone aquifers picking up calcium and magnesium.

Hardness is not a health issue, but at this level it costs money. Expect white crust on faucets and shower glass, shorter life for tankless and tank water heaters, and soap that does not lather well. For most homeowners here, a salt-based softener is worth it, and our softener vs filter guide explains why a standard filter alone will not fix scale.

Contaminants detected in San Antonio tap water

The table lists the regulated contaminants SAWS detected in its own system, using the numbers printed in the report. A detection is not a violation; the important comparison is the highest level versus the legal limit.

ContaminantHighest levelLegal limit (MCL)Health goal (MCLG)Typical source
Total trihalomethanes (TTHMs)86.2 ppb*80 ppbNone setByproduct of chlorine disinfection
Haloacetic acids (HAA5)30.6 ppb*60 ppbNone setByproduct of chlorine disinfection
Nitrate (as nitrogen)2.45 ppm10 ppm10 ppmFertilizer runoff, septic systems, natural deposits
Barium0.125 ppm2 ppm2 ppmDrilling waste, metal refineries, natural deposits
Fluoride0.69 ppm4 ppm4 ppmNatural deposits; water additive
Selenium3.1 ppb50 ppb50 ppbRefineries, mines, natural deposits
Thallium0.61 ppb2 ppb0.5 ppbOre processing; electronics, glass and drug factories
Diethylhexyl adipate1.0 ppb**0.4 (as listed)0.4 (as listed)Chemical factories
Combined radium 226/2281.5 pCi/L5 pCi/L0Natural deposits
Uranium (2024)1.7 µg/L30 µg/L0Natural deposits

*SAWS says this column shows the highest average of results collected at one sampling location over a year, and it marks both byproducts as no violation. **The report prints the units for diethylhexyl adipate as ppb; EPA’s limit for this chemical is 0.4 mg/L (400 ppb), so the detection is far below the federal limit.

Two lines stand out. Thallium was detected slightly above its health goal, though well under the legal limit. And the TTHM figure is higher than any other big-city report we have covered so far. Because TTHMs can be inhaled in steam as well as swallowed, they are one of the few reasons a whole-house carbon system can make sense on city water.

Lead and copper

In the 2024 round of home tap sampling, the 90th percentile for lead was 1.6 ppb (action level 15 ppb) and for copper 0.187 ppm (action level 1.3 ppm). No sampled site exceeded either action level. Lead mostly enters water from old service lines and plumbing, not from the aquifers. SAWS runs a free service line inspection program, Project Lead, for eligible homes built before 1989 whose line material is still listed as unknown, and you can look up your address on its service line inventory map.

Violations

None reported. The report states SAWS received no violations in 2025, and it found no E. coli positives in its monthly bacteria sampling.

Do you need a filter in San Antonio?

You do not need one to meet federal standards, but these findings point to specific upgrades:

  • Scale and hard water: a softener, optionally paired with a carbon filter, from our whole-house filter guide.
  • Chlorine taste and TTHMs: a whole-house carbon system treats every tap and shower; on a budget, a certified carbon pitcher or a shower filter from our pitchers and shower filters page covers drinking water and bathing.
  • Lead peace of mind or unknown PFAS: an under-sink or countertop system certified to NSF/ANSI 58 from our reverse osmosis guide. RO also cuts nitrate and dissolved minerals for better-tasting coffee.
  • Private well outside the SAWS area: test first, then see our well water systems.

FAQ

Is San Antonio tap water safe to drink?

According to the SAWS 2026 Water Quality Report, the system received no violations in 2025, its lead 90th percentile was 1.6 ppb with no sites over the action level, and no E. coli was found. The report lists a TTHM highest average of 86.2 ppb against an 80 ppb limit without a violation, and it contains no PFAS data. If you have an older home or want PFAS reduction, a certified RO or carbon filter adds a margin.

Why is San Antonio water so hard?

Most of it comes from limestone aquifers such as the Edwards, which dissolve calcium and magnesium into the water. SAWS says typical hardness is 15 to 20 grains per gallon, which counts as very hard.

Do I need a water softener in San Antonio?

For homeowners, usually yes. At 15 to 20 grains per gallon, scale builds quickly in water heaters, fixtures and appliances. A filter alone will not remove hardness; a softener is the tool for that.

Sources: San Antonio Water System, 2026 Water Quality Report (2025 data); SAWS Water Quality FAQs (hardness); SAWS lead and service line information. Values change yearly; everything here comes from the utility’s 2026 report and website.