Disclosure: we may earn a commission from links on this page, at no cost to you. How we choose filters.

Short answer: Boston tap water met every federal and state contaminant limit in the 2025 testing year, but Boston’s lead result did not. Water from the MWRA reservoirs leaves treatment lead-free, yet the Boston Water and Sewer Commission’s fall 2025 tap sampling found a lead 90th percentile of 22.5 ppb, above the 15 ppb action level, because some older homes still have lead service lines. If your building is old or you are unsure what your service line is made of, a filter certified for lead is a sensible step while the pipe question gets answered.
Key takeaways
- Boston tap water comes from the Quabbin and Wachusett Reservoirs in central Massachusetts and is treated by the MWRA with ozone, UV light and monochloramine.
- No regulated contaminant exceeded its legal limit in the 2025 MWRA results, and PFAS were at trace levels, well under the Massachusetts PFAS6 standard of 20 ppt.
- Boston’s lead 90th percentile was 22.5 ppb in fall 2025 sampling (4 of 33 homes above 15 ppb). That is a lead action level exceedance, driven by home plumbing and service lines, not by the source water.
- The water is very soft (about 14 mg/L, under 1 grain per gallon), so a softener is not needed.
Where Boston tap water comes from
Two agencies share the job. The Massachusetts Water Resources Authority (MWRA) owns the reservoirs, the aqueducts and the John J. Carroll Water Treatment Plant in Marlborough. The Boston Water and Sewer Commission (BWSC) buys that treated water and runs the city’s own pipes, meters and service connections. This page uses MWRA’s 2025 annual water quality results for the fully supplied communities, which include Boston’s community letter from BWSC.
The supply starts in protected forest watersheds around the Quabbin and Wachusett Reservoirs, with the Ware River adding water when needed. Together the reservoirs send out about 200 million gallons a day across the MWRA system.
At the Carroll plant the water is treated with ozone, then ultraviolet light, which together inactivate microbes such as Giardia and Cryptosporidium. MWRA adjusts pH and alkalinity with sodium carbonate and carbon dioxide to make the water less corrosive to pipes, adds fluoride, and finishes with monochloramine, a long-lasting disinfectant that keeps the water protected as it travels through the city mains.
Boston water hardness
Boston water is soft. MWRA’s August 2026 monthly water quality update lists hardness at the Carroll plant’s finished-water tap at 14.3 mg/L, which works out to roughly 0.8 grains per gallon. Anything under about 60 mg/L (3.5 gpg) is considered soft.
For a homeowner that means very little scale on kettles, faucets and water heaters, so a water softener or salt-free conditioner is not worth the money in Boston. Soft water can be slightly more aggressive toward metal pipes, which is one reason MWRA raises the pH before the water leaves the plant.
What was detected in Boston tap water
The table uses MWRA’s 2025 system-wide results, which cover the water Boston receives. MWRA reports most results as averages; the highest value and the range are shown where the report gives them. All units are as published.
| Contaminant | Highest level | Legal limit (MCL) | Health goal (MCLG) | Typical source |
|---|---|---|---|---|
| Total trihalomethanes | 35.3 ppb (avg 16.1) | 80 ppb | none set | Disinfection byproduct |
| Haloacetic acids (HAA5) | 23.2 ppb (avg 15.8) | 60 ppb | none set | Disinfection byproduct |
| Monochloramine | 3.7 ppm (avg 1.99) | 4 ppm (MRDL) | 4 ppm (MRDLG) | Added disinfectant |
| Fluoride | 0.8 ppm (avg 0.71) | 4 ppm | 4 ppm | Added for dental health |
| Nitrate | 0.64 ppm | 10 ppm | 10 ppm | Byproduct of disinfection |
| Nitrite | 0.005 ppm | 1 ppm | 1 ppm | Byproduct of disinfection |
| Barium | 0.009 ppm (avg 0.008) | 2 ppm | 2 ppm | Natural mineral |
| Radium-226 (2023 test) | 0.82 pCi/L | 5 pCi/L | 0 | Natural deposits |
Sodium peaked at 35.6 mg/L in monthly tests, which MWRA describes as very low sodium.
On PFAS, MWRA says the six compounds regulated by Massachusetts (PFAS6) have added up to zero in its tests, with PFOA and PFOS showing only trace amounts too small to quantify. That puts the supply comfortably under the state’s 20 ppt standard.
Lead and copper in Boston
This is the number that matters most for Boston households. MWRA’s water is lead-free when it leaves the reservoirs, but lead can dissolve from a lead service line, old solder or brass fixtures on the way to your tap.
- Boston (BWSC), September/October 2025: lead 90th percentile 22.5 ppb, range 0.675–203 ppb, 4 of 33 homes above the 15 ppb action level. Copper 90th percentile 79.1 ppb, 0 of 33 above the 1,300 ppb action level.
- MWRA system-wide, September 2025: lead 90th percentile 5.96 ppb, 18 of 594 homes above the action level; copper 96.6 ppb, none above.
Sampling targets higher-risk homes, including homes known to have lead service lines, so the 90th percentile is a warning flag rather than an average for the whole city. Still, it shows that some Boston homes can have high lead at the tap.
BWSC reports about 1,001 service line inspections and roughly 448 lead service line replacements in 2025, around 400 of them on private property through its no-cost replacement program. Its goal is to replace remaining lead lines and resolve unknown pipes by the end of 2032. You can check your address on BWSC’s water service map or call the Lead Hotline at (617) 989-7888.
Violations
MWRA reports no violations of any maximum contaminant level in 2025. The one exception to a clean year is the lead action level: the MWRA letter lists Boston, Malden and Medford as communities whose 2025 lead results exceeded it. An action level exceedance is not an MCL violation, but it triggers required steps such as public education and continued pipe replacement.
Do you need a filter in Boston?
Your answer depends mostly on your plumbing, not on the reservoir water.
- Older home, lead or unknown service line: use a filter certified to NSF/ANSI 53 for lead at the kitchen tap. An under-sink system or a certified pitcher works; see our reverse osmosis systems and pitcher filters. BWSC also advises running cold water for at least a minute before drinking and never boiling water to remove lead.
- Chloramine taste or smell: a whole-house carbon filter rated for chloramine can improve taste at every tap. Plain carbon designed for chlorine is less effective on chloramine, so check the claim. Start with our whole-house filters for city water.
- Hard water: not an issue in Boston, so skip the softener.
- Private well outside the MWRA area: your water is not covered by this report; see our well water guide.
Boston tap water FAQ
Is Boston tap water safe to drink?
MWRA reports that its water met every state and federal standard in 2025, with no MCL violations and PFAS at trace levels. However, Boston’s fall 2025 lead 90th percentile was 22.5 ppb, above the 15 ppb action level. If your home may have a lead service line, use a lead-certified filter and check your line with BWSC.
Does Boston tap water have lead?
The source water does not, but some homes do at the tap. In BWSC’s 2025 sampling, 4 of 33 higher-risk homes were above 15 ppb and the highest result was 203 ppb. Lead comes from service lines and older plumbing, so testing your own tap is the only way to know.
Is Boston water hard or soft?
Soft. MWRA’s August 2026 monthly data shows hardness of 14.3 mg/L at the treatment plant, under 1 grain per gallon, so scale is rarely a problem and a softener is unnecessary.
Values change every year. All figures above come from the MWRA 2025 annual water quality results and Boston’s community letter, plus MWRA’s monthly update for hardness.
Sources: MWRA 2025 Annual Water Quality Test Results (full-service communities, including Boston); Boston Water and Sewer Commission lead information notice (2025); MWRA monthly water quality update, August 2026; MWRA PFAS information.