Cleveland Tap Water: What’s in It and the Best Filter

Disclosure: we may earn a commission from links on this page, at no cost to you. How we choose filters.

Cleveland Tap Water: What's in It and the Best Filter: illustration of a city skyline with a water drop

Short answer: Cleveland tap water met every federal and Ohio drinking water standard in 2025, according to Cleveland Water’s 2025 Water Quality Report, and the utility listed no violations. Cleveland tap water comes from Lake Erie, is treated with chlorine, and is moderately hard, so the main reasons to add a filter are chlorine taste, older lead plumbing in some homes, and scale.

Key takeaways

  • Cleveland Water reported zero violations for 2025 and says it holds an unconditioned operating license from Ohio EPA.
  • Lead at the 90th percentile was 3.15 ppb in the 2024 sampling round, well under the 15 ppb action level, but one of 52 samples came back extremely high (1,997 ppb). Homes with lead service lines should take that seriously.
  • All 29 PFAS tested under EPA’s UCMR 5 program were not detected in 646 tests at the four plants.
  • Average hardness is about 117 (as calcium carbonate), roughly 6.8 grains per gallon: moderately hard.

Where Cleveland tap water comes from

Every drop starts in the Central Basin of Lake Erie. Cleveland Water draws it through four intakes spread across about 15 miles of shoreline, each sitting 3 to 5 miles offshore, with intake tunnels running roughly 50 feet below the lake bed. Ohio EPA rates the intake water as having low susceptibility to contamination, according to the 2021 assessment cited in the report.

Four conventional treatment plants handle the water: Garrett A. Morgan (about 60 million gallons a day), Baldwin (about 59.5), Nottingham (about 50) and Crown (about 40). Together they serve roughly 1.4 million customers in 80 communities, which makes Cleveland Water one of the largest systems in the Great Lakes region. If you live in a suburb that buys water from Cleveland, this report still applies to you.

How the water is treated

The plants run a classic sequence: coagulation with alum, flocculation, settling, and filtration through two feet of anthracite over a foot of sand. Potassium permanganate and powdered activated carbon help with taste and odor. Disinfection uses sodium hypochlorite, which is chlorine, not chloramine. Fluoride is added, sodium hydroxide raises the pH, and phosphoric acid supplies orthophosphate, a coating that helps keep lead and copper from dissolving out of old pipes.

Because the disinfectant is free chlorine, a basic carbon filter does a good job on the bleach-like smell some people notice. That’s an easier job than removing chloramine, which needs catalytic carbon.

Cleveland water hardness

The report lists hardness as calcium carbonate between 105 and 130, with an average of 117. In the usual mg/L (ppm) unit that comes to roughly 6.1 to 7.6 grains per gallon, about 6.8 on average. Calcium averages 16 ppm and magnesium 7.6 ppm.

That puts Cleveland in the moderately hard band. You’ll see some white crust on faucets, glass shower doors and the inside of kettles, and a tank water heater will collect sediment over the years. Most households manage fine with occasional descaling. A water softener is a comfort upgrade rather than a necessity here. If you’re weighing it, our guide to softeners versus filters for hard water explains the trade-offs.

Contaminants detected in Cleveland tap water

The table uses the highest level Cleveland Water reported across its four plants (disinfection byproducts are reported as one distribution-system value). Values come from the utility’s 2025 report and change every year.

ContaminantHighest levelLegal limit (MCL)Health goal (MCLG)Typical source
Total trihalomethanes (TTHM)39.4 ppb (range 9.8–65.4)80 ppbNone setByproduct of chlorination
Haloacetic acids (HAA5)14.7 ppb (range 6.0–14.7)60 ppbNone setByproduct of chlorination
Fluoride1.02 ppm (Baldwin; range 0.76–1.26)4 ppm4 ppmAdded for dental health
Nitrate (as N)0.48 ppm (Nottingham)10 ppm10 ppmFertilizer runoff, septic systems, erosion
Cyanide40 µg/L (Morgan only; range ND–40)200 µg/L200 µg/LPlastic and fertilizer factory discharge
Turbidity0.22 NTU (Baldwin); 100% of samples met the standardTreatment techniqueNone setSoil runoff
Total chlorine1.20 ppm average (Nottingham; range 1.01–1.40)4 ppm (MRDL)4 ppm (MRDLG)Disinfectant added at the plant
Total coliform0.00% positive (0 of 4,261 samples)Under 5% positive0Naturally present in the environment

One oddity worth knowing: the plant table shows a single cyanide detection at the Morgan plant, while the report’s plant-wide averages list cyanide as not detected. Either way, the reported figure is a fifth of the legal limit. Sodium averaged 10 ppm, and total dissolved solids averaged 180 ppm.

Lead and copper in Cleveland

Lead and copper were sampled at 52 homes between June and September 2024. The 90th-percentile lead result was 3.15 ppb against an action level of 15 ppb, and copper’s 90th percentile was 0.06 ppm against 1.3 ppm. That passes the rule, which is only triggered if more than 10% of samples exceed the action level.

The detail that matters for individual homes is the outlier: one sample measured 1,997 ppb. That kind of spike usually points to plumbing inside or right outside a specific building, not the treated water leaving the plant. The report confirms that some Cleveland properties still have lead service lines or lead plumbing, though it gives no count. You can look up your address in the utility’s online service line inventory and request help through its lead line (216-664-2882). If your line is lead, galvanized or unknown, use a filter certified for lead until it’s replaced. Our guide to what filter removes lead lists the certifications to look for.

Violations

None reported. Every row in the 2025 report is marked “No” in the violation column, and the utility states it met or surpassed all federal and state requirements.

Do you need a filter in Cleveland?

For most households, a filter here is about taste and peace of mind rather than fixing a failing system. Match the filter to what you actually want to solve:

  • Chlorine taste or smell: a carbon pitcher or faucet filter certified to NSF/ANSI 42 handles it cheaply. See our pitcher and shower filter picks.
  • Lead service line or older plumbing: choose a filter certified to NSF/ANSI 53 for lead, or an under-sink reverse osmosis system. Our reverse osmosis guide covers the options.
  • Chlorine in showers and every tap: a whole-house carbon filter treats all the water entering the home.
  • Scale from moderately hard water: a softener is optional; descaling fixtures may be enough.
  • Private well outside the service area: the report doesn’t apply to you; start with our well water guide.

PFAS is less of a driver in Cleveland than in many cities, since none of the 29 compounds tested were found. If you still want extra margin, the same reverse osmosis systems that handle lead also reduce PFAS.

FAQ

Is Cleveland tap water safe to drink?

Cleveland Water’s 2025 Water Quality Report says the water met all federal and Ohio standards and lists no violations. Lead at the 90th percentile was 3.15 ppb in 2024 sampling, but one home tested far higher, so homes with lead service lines should use a lead-certified filter. None of the 29 PFAS tested under UCMR 5 were detected.

Does Cleveland have hard water?

Yes, moderately. The 2025 report lists average hardness of 117 as calcium carbonate (range 105–130), about 6.8 grains per gallon. Expect some scale on fixtures; a softener is optional.

Does Cleveland use chlorine or chloramine?

Chlorine. The report says Cleveland Water disinfects with sodium hypochlorite, and average total chlorine at the plants ranged from about 1.09 to 1.20 ppm in 2025.

Sources: Cleveland Water 2025 Water Quality Report (Department of Public Utilities, City of Cleveland) and the Cleveland Water water quality page. All values come from the utility’s 2025 report and change from year to year; lead and copper figures are from 2024 sampling.