Denver Tap Water: What’s in It and the Best Filter

Disclosure: we may earn a commission from links on this page, at no cost to you. How we choose filters.

Denver Tap Water: What's in It and the Best Filter: illustration of a city skyline with a water drop

Denver tap water met every federal and Colorado drinking water standard in 2025, according to Denver Water’s 2026 Water Quality Report, and the only problem it lists is a missed sampling round at a backup plant. The real decision for most households is lead: Denver still has tens of thousands of lead service lines, so older homes should test and consider a certified filter.

Short answer

Denver tap water starts as mountain snowmelt, is treated at three main plants, and is disinfected with chloramine. It is moderately hard (about 6 grains per gallon on average), PFAS were below federal reporting levels in recent testing, and disinfection byproducts sat well under their limits. If your house was built before 1951, find out what your service line is made of before you pick a filter.

Key takeaways

  • No health-based violations in 2025. Denver Water reports one monitoring violation: one of two required sample sets for synthetic organic chemicals was not collected at the Moffat plant, which was offline for much of the period.
  • Lead is a house-by-house issue. The 90th-percentile lead result was 4 ppb in the first half of 2025 and 3.1 ppb in the second half, under the 15 ppb action level, but four homes tested above it, one at 126.1 ppb.
  • Chloramine, not plain chlorine. That matters if you keep fish, run dialysis at home, or want a carbon filter that can handle it.
  • Moderately hard water. Expect some spotting and scale, but most homes don’t need a softener.

Where Denver’s water comes from

Denver Water serves about 1.5 million people in Denver and many surrounding suburbs. All of its supply is surface water from rivers and streams fed by snowmelt on both sides of the Continental Divide. It is held in mountain reservoirs such as Antero, Eleven Mile Canyon, Cheesman, Dillon and Gross, then in terminal reservoirs at Strontia Springs, Marston and Ralston before it reaches a plant.

In 2025, the Foothills, Marston and Northwater plants did most of the treatment, while Moffat served as a backup and sat offline for most of the year. After filtration, Denver Water adds chloramine to keep the water disinfected as it travels through the pipes. It also raises the water’s pH to make it less corrosive to lead plumbing.

Denver water hardness

The 2026 report lists total hardness at an average of 105,009 ppb, with samples ranging from 55,000 to 124,000 ppb. Those numbers look big because they’re in parts per billion. Converted, the average is about 105 mg/L, or roughly 6.1 grains per gallon (gpg), with a range of about 3.2 to 7.3 gpg.

That puts Denver in the “moderately hard” to “hard” band. You’ll probably see white film on glass shower doors and some buildup in kettles and the water heater over time, but it’s far milder than Phoenix or Las Vegas. A whole-house softener is optional here. It makes the most sense if you have a tankless heater, or if the spotting truly bothers you. Our guide on whether you need a softener or a filter for hard water walks through the trade-offs.

What’s in Denver tap water: detected contaminants

These are the regulated substances Denver Water detected at its treatment plants and in the distribution system in 2025. Values are the highest figures the report lists across plants (ppb = parts per billion).

ContaminantHighest levelLegal limit (MCL)Health goal (MCLG)Typical source
Barium45.1 ppb (plant averages 20.2–40.1)2,000 ppb2,000 ppbErosion of natural deposits
Fluoride750 ppb (plant averages 573–619)4,000 ppb4,000 ppbNatural deposits; water additive
Nitrate (as N)187 ppb10,000 ppb10,000 ppbFertilizer runoff; septic systems; erosion
Chromium (total)1.8 ppb100 ppb100 ppbMill discharge; erosion
Mercury0.115 ppb2 ppb2 ppbErosion; refinery and landfill runoff
Total trihalomethanes (TTHM)35.5 ppb highest running average (range 8.8–41.1)80 ppbNone setByproduct of disinfection
Haloacetic acids (HAA5)19.5 ppb highest running average (range 7.2–26.7)60 ppbNone setByproduct of disinfection
Total coliform0.5% of samples in the worst month (3 of 4,770 for the year)5% per month0Naturally present in the environment
Turbidity0.170 NTU (single highest reading)1 NTU, treatment techniqueNone setSoil runoff

PFAS: Denver Water says it has tested source and treated water for PFAS since 2017. In federal UCMR 5 testing (2023–2025), every PFAS compound on the list was below the minimum reporting level at every plant.

Lead and copper in Denver

Lead doesn’t come from Denver’s rivers. It gets into tap water from lead service lines, lead solder and older brass fixtures inside or near the home. Here are the 2025 tap sample results:

PeriodLead 90th percentileHomes over 15 ppbCopper 90th percentileHomes over 1,300 ppb
January–June 2025 (337 homes)4 ppb160 ppb0
July–December 2025 (245 homes)3.1 ppb340 ppb0

Denver Water’s Lead Reduction Program, approved in 2019, is replacing an estimated 60,000 to 64,000 lead service lines with copper at no direct charge to customers. Homes the utility suspects have a lead line get a free certified pitcher and filters until the line is replaced, plus six months after. Homes built before 1951 are the most likely to have one, homes built before 1987 may have lead solder, and faucets sold before 2014 may not meet today’s “lead-free” rules. You can order a free lead test kit from Denver Water and look up your address on its service line map.

Violations

No health-based violations were reported for 2025. The report lists one monitoring violation: Denver Water collected only one of the two synthetic organic compound sample sets required at the Moffat plant during the 2023–2025 period. The utility says this posed no safety risk, that no such compounds were found at Moffat in 2024 or at Northwater (which uses the same source), and that it has changed its sampling schedules.

Do you need a filter in Denver?

That depends on your house more than the city’s treatment plants:

  • Possible lead line, or a home built before 1987: use a filter certified to NSF/ANSI 53 for lead. A pitcher works for drinking water; an under-sink system is easier for cooking too. Start with our reverse osmosis guide or pitcher and shower filter picks.
  • You dislike the chloramine taste: many basic carbon filters handle chlorine better than chloramine. Look for a filter that specifically claims chloramine reduction under NSF/ANSI 42.
  • Scale and spotting: a softener or a whole-house system with scale control can help, though it’s optional at about 6 gpg. Compare options on our whole-house filter page.
  • Private well outside Denver Water’s area: the report above doesn’t apply. See our well water guide.

FAQ

Is Denver tap water safe to drink?

Denver Water’s 2026 report says its water met all federal and state standards for regulated contaminants in 2025, with one monitoring violation and no health-based violations. Lead can still enter from a home’s service line or plumbing, so homes with a known or suspected lead line should use a certified filter. PFAS were below federal reporting levels in recent testing.

Does Denver use chlorine or chloramine?

Denver Water adds chloramine after filtration. If you want to remove it for taste, choose a carbon or reverse osmosis filter that lists chloramine reduction, not just chlorine.

How hard is Denver water?

The 2026 report gives an average total hardness of 105,009 ppb, which works out to about 105 mg/L or 6.1 grains per gallon. That’s moderately hard, so a softener is optional.

Sources

Sources: Denver Water 2026 Water Quality Report (2025 data) and Denver Water’s treated water quality summary. Values change every year. All figures on this page come from the utility’s 2026 report, which covers 2025 testing.