Disclosure: we may earn a commission from links on this page, at no cost to you. How we choose filters.

Short answer: Phoenix tap water stayed under every health-based limit in the City of Phoenix Water Services Department’s 2025 water quality report; the only issue listed was a one-sample shortfall in routine monitoring that the city says posed no health risk. What stands out is the water’s character: it is very hard, high in dissolved minerals and sodium, and carries detectable arsenic and a chlorine taste.
Key takeaways
- About 97 to 99 percent of Phoenix tap water came from surface water in 2025: the Salt and Verde rivers plus Colorado River water delivered by the Central Arizona Project.
- Hardness ran 10 to 17.6 grains per gallon, which is hard to very hard. Scale on fixtures and appliances is the most common complaint.
- Arsenic reached a highest annual average of 7 ppb, under the 10 ppb limit but above the health goal of zero.
- Total dissolved solids (464–716 ppm) often exceed the 500 ppm taste guideline, which is why many residents use reverse osmosis for drinking water.
Where Phoenix tap water comes from
The City of Phoenix Water Services Department serves Phoenix from a mix of rivers and wells. Most supply is surface water that starts largely as snowpack: the Salt and Verde rivers, managed through the Salt River Project canal network, and Colorado River water carried across the desert by the Central Arizona Project canal (some of it blended with Agua Fria River water at Lake Pleasant). Roughly 20 city wells supply the remaining small share, about 1 to 3 percent.
Five treatment plants clean the water. Chlorine is the disinfectant in the pipes, and some plants also use chlorine dioxide and/or ozone to remove iron and manganese. Chlorine in the distribution system had a highest running annual average of 0.84 ppm, well under the 4 ppm maximum. Because Phoenix uses free chlorine rather than chloramine, a basic carbon filter does a good job with taste and odor.
Desert rivers pick up a lot of minerals on their way to the city, and that shapes nearly everything about how the water behaves at home: hardness, white crust on faucets, and a slightly salty or mineral taste in summer.
Phoenix water hardness
The 2025 report lists total hardness of 172 to 302 ppm, or 10 to 17.6 grains per gallon. Anything above about 10.5 grains per gallon is considered very hard, so much of Phoenix sits at the top of the scale.
In practice that means scale builds quickly inside water heaters, evaporative coolers, dishwashers and shower heads. Tankless water heaters in particular need regular flushing. Soap lathers poorly and glassware spots.
For homeowners who plan to stay put, a water softener or a whole-house scale-control system is often worth it in Phoenix, more so than in most US cities. Two points to weigh: salt-based softeners add sodium, and the report already lists sodium at 91 to 183 ppm. A salt-free conditioner, or softening paired with a drinking-water RO unit, avoids much of that. See our whole-house filter guide for options.
What Phoenix detected in 2025
These are the regulated substances found in Phoenix’s treated water. None exceeded its legal limit. ppm = parts per million, ppb = parts per billion. “Highest level” is the highest annual average where the city reported one, otherwise the top of the detected range.
| Contaminant | Highest level | Legal limit (MCL) | Health goal (MCLG) | Typical source |
|---|---|---|---|---|
| Arsenic | 7 ppb (range ND–8.5) | 10 ppb | 0 | Natural deposits, orchard runoff |
| Nitrate (as N) | 3.8 ppm (range ND–4.5) | 10 ppm | 10 ppm | Fertilizer runoff, septic systems |
| Chromium | up to 87 ppb | 100 ppb | 100 ppb | Steel mills, natural deposits |
| Fluoride | up to 1.1 ppm | 4 ppm | 4 ppm | Natural deposits, water additive |
| Barium | up to 0.13 ppm | 2 ppm | 2 ppm | Drilling and refinery discharge, natural deposits |
| Uranium | up to 4.6 ppb | 30 ppb | 0 | Natural deposits |
| Selenium | up to 2.2 ppb | 50 ppb | 50 ppb | Refineries, natural deposits |
| Combined radium | up to 0.8 pCi/L | 5 pCi/L | 0 | Natural deposits |
| Total trihalomethanes | 49 ppb (highest annual average) | 80 ppb | none set | Chlorine disinfection byproduct |
| Haloacetic acids (HAA5) | 17 ppb (highest annual average) | 60 ppb | none set | Chlorine disinfection byproduct |
| Chlorite | 0.3 ppm (highest quarterly) | 1 ppm | 0.8 ppm | Chlorine dioxide byproduct |
The report also lists two unregulated PFAS from sampling in 2023 and early 2024: PFBS at 0.011 ppb and PFBA at 0.005 ppb on average. Neither has a federal limit. PFOA and PFOS, the two PFAS most new rules target, were not among the detections listed.
Lead and copper in Phoenix
Phoenix was not required to sample lead and copper in 2025, so the report repeats its 2024 results from 56 homes:
- Lead: 90th percentile 3 ppb, under the 15 ppb action level. Two of 56 taps were above 15 ppb, with a highest result of 41.8 ppb.
- Copper: 90th percentile 0.3 ppm, under the 1.3 ppm action level. No taps were above it.
Lead at the tap usually comes from service lines, solder or brass fixtures inside a building, not from the treated water itself. If your home predates 1988, a lead-certified filter for drinking water is a sensible step.
Violations
The city reported one monitoring issue. In May 2025, Phoenix counted six repeat samples as routine ones, leaving it with 359 routine bacteria samples instead of the required 360. The city states no E. coli was found and the incident posed no health risk. No limits were exceeded for any contaminant.
Do you need a filter in Phoenix?
Most people here filter for taste and scale more than for safety. Match the system to the goal:
- Mineral taste, arsenic and high dissolved solids: an under-sink reverse osmosis system certified to NSF/ANSI 58. RO is the most practical way to cut TDS, sodium and arsenic at the kitchen tap.
- Scale throughout the house: a softener or scale-control unit, ideally paired with a whole-house carbon filter to take out chlorine.
- Chlorine taste on a budget: a certified pitcher or faucet filter. It helps with chlorine but will not lower hardness or TDS much.
- Dry skin or hair: a shower filter can reduce chlorine, though it won’t soften very hard water.
If your home is on a private well outside city service, see our well water guide instead.
FAQ
Is Phoenix tap water safe to drink?
Phoenix tap water met all health-based federal limits in the city’s 2025 report. The only issue listed was a monitoring shortfall of one bacteria sample, which the city says posed no health risk. Lead results depend on home plumbing, and arsenic is present below its limit, so an RO system is worth considering if either concerns you.
Why does Phoenix water taste bad?
Phoenix water is high in minerals, with dissolved solids of 464 to 716 ppm and sodium of 91 to 183 ppm in the 2025 report, plus a chlorine residual. That combination gives a mineral, slightly salty or pool-like taste, which reverse osmosis reduces well.
Is a water softener worth it in Phoenix?
For many homes, yes. At 10 to 17.6 grains per gallon, Phoenix water is very hard, and a softener or scale-control system protects water heaters and fixtures.
Sources: City of Phoenix Water Services Department, 2025 Water Quality Report (PDF) and City of Phoenix water quality reports page. Values change yearly; figures on this page come from the utility’s 2025 report.