Disclosure: we may earn a commission from links on this page, at no cost to you. How we choose filters.

Short answer
San Diego tap water had no drinking water limit (MCL) violations in 2025, according to the City of San Diego Public Utilities Department’s 2025 water quality report. The bigger day-to-day issues are hardness (around 14 grains per gallon from the city’s three plants), the taste of chloramine, and fairly high dissolved minerals, so most homes are choosing a filter for comfort and taste rather than to fix a legal problem.
Key takeaways
- No MCL violations in 2025. Disinfection byproducts stayed below their limits, and lead was not detected at the 90th percentile in the latest tap study.
- Very hard water. City plant averages run 237 to 243 mg/L, or about 13.8 to 14.2 grains per gallon.
- Chloramine, not chlorine, stays in the pipes, so a plain carbon pitcher filter may not take out all of the treatment taste.
- Mostly imported water. San Diego tap water is largely a blend of Colorado River and State Water Project supply bought through the San Diego County Water Authority.
Where San Diego tap water comes from
San Diego has little rain and few local rivers, so most of its supply is imported. The city buys most of its water from the San Diego County Water Authority, and the report describes that water as mainly a blend of Colorado River and State Water Project water. The city’s own Alvarado, Miramar and Otay plants treat that raw water along with runoff stored in local reservoirs. A smaller share, under 10 percent of imports, arrives already treated from other plants, including the Carlsbad desalination plant.
The three city plants feed one connected network, so a single house can receive water from more than one plant during the year. Alvarado and Miramar use ozone as the main disinfectant, while Otay uses chlorine dioxide. Before the water leaves for homes, chloramine (chlorine combined with ammonia) is added to keep it protected in the pipes. In 2025, the chloramine residual averaged 1.75 ppm, below the 4.0 ppm ceiling.
The report also notes that the Pure Water recycling program is not a source yet; the city expects its first purified water in early 2027.
San Diego water hardness
San Diego water hardness is among the highest of any big city we cover. The 2025 report lists these averages:
- Alvarado plant: 237 mg/L (13.8 grains per gallon)
- Miramar plant: 242 mg/L (14.1 grains per gallon)
- Otay plant: 243 mg/L (14.2 grains per gallon)
- Purchased treated water: 145 mg/L (8.5 grains per gallon)
Anything above about 10.5 grains per gallon is usually called very hard. At these levels you can expect white crust on faucets and shower glass, spots on dishes, and faster scale buildup in water heaters and tankless units. Hardness is not a health problem, but if scale is costing you appliance life, a salt-based softener or a whole-house system is worth pricing. San Diego’s total dissolved solids also run high (about 532 to 585 ppm at the city plants), which is part of why some people find the water tastes mineral-heavy.
Detected contaminants in San Diego tap water
The table below uses figures from the City of San Diego’s 2025 report. “Highest level” is the top plant average or the highest running annual average, as the report lists it. ND means not detected.
| Contaminant | Highest level | Legal limit (MCL) | Health goal (MCLG/PHG) | Typical source |
|---|---|---|---|---|
| Total trihalomethanes (TTHM) | 55 ppb (highest LRAA; single results 8.6–87.0) | 80 ppb | none | Disinfection byproduct |
| Haloacetic acids (HAA5) | 15 ppb (highest LRAA) | 60 ppb | none | Disinfection byproduct |
| Bromate | 3.4 ppb avg in purchased water (range ND–13) | 10 ppb | 0.1 ppb | Byproduct of ozone treatment |
| Chlorite | 0.33 ppm avg at Otay (range 0.028–0.68) | 1.0 ppm | 0.05 ppm | Byproduct of chlorine dioxide |
| Fluoride (with treatment) | 0.8 ppm avg at Alvarado | 2 ppm | 1 ppm | Natural; added for dental health |
| Uranium | 2.2 pCi/L at Alvarado | 20 pCi/L | 0.43 pCi/L | Natural erosion |
| Gross alpha | 4.4 pCi/L at Alvarado | 15 pCi/L | 0 | Natural erosion |
| Barium | 0.1 ppm | 1 ppm | 2 ppm | Natural erosion |
| Nitrate (as N) | up to 0.5 ppm in purchased water | 10 ppm | 10 ppm | Fertilizer runoff, erosion |
California sets public health goals (PHGs), which the report lists in place of federal MCLGs. Several of these goals sit below the detected amounts, which is common and does not mean a limit was broken.
On PFAS, the city says 29 compounds tested under the EPA’s UCMR 5 program in 2023 were not found above reporting levels, although the detected-parameters table lists PFBA at the Alvarado plant at an average of 5.4 parts per trillion (range ND–7.0). PFBA is not one of the PFAS with a federal limit.
Lead and copper
The latest round of home tap sampling in the report was in 2023 at 56 sites. Lead at the 90th percentile was not detected, with a top result of 1.4 ppb and no homes over the 15 ppb action level. The report lists copper at 0.6 ppm at the 90th percentile, under the 1.3 ppm action level, with one home above it. The city’s service line inventory did not identify any lead in the system. Lead can still come from older faucets and solder inside a building, so the first water out of a tap that has sat for hours is the most likely to carry it.
Violations
No MCL violations were reported in 2025. The report separately mentions a 2023 state notice that the city had not fully carried out its cross-connection control program (backflow surveys); it says the city reached 45 percent of required surveys in 2025. It also notes one Otay chlorate sample above California’s 800 ppb notification level, with a lower confirmation sample.
Do you need a filter in San Diego?
Your answer depends on what bothers you:
- Scale and spots: a softener or whole-house system aimed at hardness. A carbon filter alone will not reduce hardness.
- Chloramine taste: look for catalytic carbon with a chloramine reduction claim. Whole-house carbon units and many under-sink systems do this.
- High minerals and extra peace of mind on PFAS or byproducts: an under-sink reverse osmosis system lowers dissolved solids, sodium and many PFAS at the kitchen tap.
- Renters or small budgets: a certified pitcher or shower filter helps taste, though it will not fix hardness.
If your home is on a private well outside city service, see our well water guide instead.
FAQ
Is San Diego tap water safe to drink?
The City of San Diego’s 2025 report lists no MCL violations for the year; it does note an open state notice about the city’s backflow (cross-connection) survey program. Lead was not detected at the 90th percentile in the 2023 tap study. The city reports no PFAS above reporting levels in 2023 testing, though its table lists low PFBA at one plant.
Why is San Diego water so hard?
Most of the supply is imported Colorado River and State Water Project water, which picks up calcium and magnesium along the way. City plant averages were 237 to 243 mg/L in 2025, roughly 14 grains per gallon.
Does San Diego use chlorine or chloramine?
Chloramine. The city’s plants use ozone or chlorine dioxide first, then add chloramine to protect the water in the pipes. Its average residual in 2025 was 1.75 ppm.
Sources
Values change every year; the figures above come from the City of San Diego’s 2025 report.
Sources: City of San Diego Public Utilities Department, 2025 Annual Drinking Water Quality Report; City of San Diego water quality reports page.