AquaTru Countertop Reverse Osmosis Review

Disclosure: we may earn a commission from links on this page, at no cost to you. How we choose filters.

AquaTru Countertop Reverse Osmosis Review: illustration of a review badge with a check mark

The AquaTru countertop reverse osmosis purifier is one of the few no-install RO systems with third-party certification behind its main claims: AquaTru’s documents say IAPMO certified it to NSF/ANSI 42, 53, 58 and 401 plus NSF P473 for PFOA and PFOS. In this AquaTru review, we look at what that covers, what it costs to run each year, and who should pick a different setup.

Short answer

If you rent, can’t drill a hole in your sink, or just want reverse osmosis water without a plumber, the AquaTru Classic is a strong choice. You fill a tank with tap water, and it pushes the water through four stages and into a clean-water tank. The trade-offs are counter space, small batches (under a gallon at a time), and about $130 a year in filters at official two-year-pack pricing.

Key takeaways

  • Certified, not just “tested.” The performance data sheet lists IAPMO certification to five standards, including NSF/ANSI 58 (reverse osmosis) and P473 (PFOA/PFOS).
  • No plumbing. It plugs into a regular 120V outlet and sits on the counter.
  • Less waste than many RO systems. The data sheet rates efficiency at 75%; older under-sink RO units often send far more water down the drain.
  • Batch-based. It makes clean water a tank at a time, so heavy users will refill often.

AquaTru Classic quick facts

SpecAquaTru Classic (per official pages)
TypeCountertop reverse osmosis, 4 stages
PriceAbout $475 (Smart/app version about $525)
CertificationsIAPMO to NSF/ANSI 42, 53, 58, 401 and NSF P473
Filter lifePre/carbon: 6 months; VOC carbon: 1 year; RO membrane: 2 years or 1,200 gallons
Two-year filter packAbout $259.65 (about $130 per year)
Efficiency rating75% (54 gallons per day production rate)
Purified tankAbout 0.75 gallon
Power120V wall outlet
Warranty1-year limited, 30-day money-back guarantee

Prices are approximate and change often; check the official AquaTru Classic page for the current figure.

How the AquaTru works

You pour tap water into a removable tank on the back, press start, and the unit’s pump sends it through four stages:

  1. Pre-filter for sediment and rust.
  2. Activated carbon for chlorine and chloramine.
  3. Reverse osmosis membrane, which handles dissolved solids and heavy metals such as lead and arsenic.
  4. VOC carbon filter, a final polish that AquaTru says targets volatile organic chemicals plus PFOA and PFOS.

Purified water collects in a front tank with a pour spout, and the rejected water returns to the tap-water tank, which you empty now and then. AquaTru’s manual says a full tank normally takes about 15 minutes, and if it starts taking more than 30, the RO filter likely needs replacing. A filter-life indicator counts gallons and tells you when each cartridge is due.

Who it’s for, and who it isn’t

Good fit:

  • Renters and anyone who can’t modify plumbing.
  • Homes on city water where the concern is lead, PFAS, arsenic, nitrate or fluoride, and the goal is drinking and cooking water only.
  • Small households that drink a few gallons a day or less.

Not a good fit:

  • Big families who want water on demand. A plumbed under-sink reverse osmosis system with a storage tank or a tankless design is easier.
  • Untreated well water. The manual says to use it only on municipally treated water or a supply known to be microbiologically safe. Start with our well water guide instead.
  • Very hard water. The manual lists a 10 grains per gallon maximum. Above that, scale shortens filter life; a softener or whole-house treatment may be needed first.
  • Anyone who wants filtered water for showers and laundry, which a countertop unit can’t provide.

Certifications

AquaTru’s performance data sheet and owner’s manual state that the countertop models (AT2000 through AT2050) are certified by IAPMO against NSF/ANSI 42, 53, 58 and 401 and NSF P473. Here’s what each covers:

  • NSF/ANSI 42: taste and odor, including chlorine and chloramine.
  • NSF/ANSI 53: health-related contaminants such as lead, VOCs and trihalomethanes.
  • NSF/ANSI 58: reverse osmosis performance, including total dissolved solids, arsenic, fluoride, nitrate and hexavalent chromium.
  • NSF/ANSI 401: emerging contaminants such as certain pharmaceuticals and pesticides.
  • NSF P473: PFOA and PFOS.

Selected average reductions from the data sheet: lead 99.1%, PFOA and PFOS 97.5% (minimum), arsenic V 98.0%, fluoride 93.5%, hexavalent chromium 97.2%, nitrate 87.2% and total dissolved solids 87.1%. AquaTru’s support center says the listing appears in IAPMO’s online product directory under AquaTru LLC, which you can search to confirm. P473 covers only PFOA and PFOS, not every PFAS chemical; for the bigger picture, read what filter removes PFAS.

Costs, including yearly filters

At official pricing, the Classic costs about $475 up front. The Smart version, which adds an app, runs about $525, and alkaline “mineral boost” versions cost about $20 more.

Ongoing costs come from three cartridges:

  • Pre/carbon filter: replace every 6 months.
  • VOC carbon filter: replace every year.
  • RO filter: replace every 2 years or 1,200 gallons, about $59.95 on its own.

AquaTru’s two-year combo pack (four pre/carbon, two VOC and one RO filter) is listed at about $259.65, which works out to roughly $130 a year. A filter subscription cuts that by 20%, per the product page. Spread over 1,200 gallons, that’s about 22 cents a gallon for filters, less than most bottled water. Heavy use or poor water can shorten cartridge life, so your cost may be higher.

Installation and upkeep

There’s nothing to install. Unbox it, insert the three cartridges, flush the first few tanks per the manual, and plug it in. The spec sheet lists a footprint of about 12 by 14 inches and a height of about 14 inches, so check the clearance under your upper cabinets. You’ll need to empty the tap-water tank of reject water from time to time and clean the tanks periodically. In areas with harder water, AquaTru sells a descaling kit.

Pros and cons

Pros

  • Third-party certification to five standards, including RO and PFOA/PFOS.
  • No plumbing, drilling or installer.
  • 75% efficiency rating, better than many conventional RO systems.
  • Clear filter schedule and a built-in life indicator.

Cons

  • Takes up a lot of counter space.
  • Under a gallon per batch; you’ll refill often.
  • About $130 a year in filters at official pack prices.
  • Only a 1-year warranty.
  • Not meant for untreated well water or water above 10 gpg hardness.
  • Removes minerals along with contaminants (the alkaline filter option adds some back).

Verdict

For city-water households that want certified RO drinking water without touching the plumbing, the AquaTru Classic is easy to recommend. Its certification paperwork is stronger than most countertop competitors offer, its efficiency is good, and the filter schedule is simple. If you drink a lot of water, have room under the sink, or own your home, a plumbed system usually costs less per gallon and saves counter space. Compare those in our reverse osmosis hub.

FAQ

Is the AquaTru NSF certified?

AquaTru’s performance data sheet says the countertop models are certified by IAPMO, an accredited certifier, against NSF/ANSI 42, 53, 58 and 401 and NSF P473. That’s certification to NSF standards by IAPMO rather than by NSF itself.

How often do you change AquaTru filters?

Per AquaTru, the pre/carbon filter lasts 6 months, the VOC carbon filter 1 year, and the RO filter 2 years or 1,200 gallons, whichever comes first. The unit’s indicator tracks usage for you.

Does the AquaTru remove fluoride and PFAS?

Its data sheet lists an average fluoride reduction of 93.5% and certified reduction of PFOA and PFOS under NSF P473 (at least 97.5%). P473 doesn’t cover every PFAS compound, so check the data sheet for the specific chemicals you care about.

Sources

Sources: AquaTru Classic official product page, AquaTru two-year filter pack, AquaTru RO filter page, and AquaTru’s support article on certifications and data sheets, plus the AquaTru AT2000/AT2010 owner’s manual. We did not test this unit hands-on; this review relies on official specifications and certification documents. See more reviews.