Disclosure: we may earn a commission from links on this page, at no cost to you. How we choose filters.

Short answer: Miami tap water met every current maximum contaminant level in Miami-Dade Water and Sewer’s 2025 report, but it carries PFAS at levels above the new federal limits that utilities must meet in the coming years. The Main System’s highest PFOS result was 33 ppt and PFOA 13 ppt, against a federal limit of 4 ppt for each. If PFAS is your concern, the fix is at the kitchen tap: a reverse osmosis system or another filter certified for PFOA and PFOS reduction.
Key takeaways
- Miami tap water is groundwater pumped mostly from the shallow Biscayne Aquifer, softened with lime, filtered and disinfected with chloramine.
- All 22 parameters detected in 2025 were below their maximum contaminant levels, and no violations were listed.
- PFAS stand out: PFOS up to 33 ppt and PFOA up to 13 ppt in the Main System. The new federal PFAS limits are not enforceable yet, which is why these are not violations.
- Lead was low (90th percentile 3.2 ppb, 1 of 102 homes above the action level), but older homes should still check their service line.
Where Miami tap water comes from
The City of Miami does not run its own water utility. Miami-Dade Water and Sewer Department (WASD) supplies the city and much of the county, more than 2.8 million people a day, so its report is the one that applies to most Miami residents. Miami Beach and several other cities buy WASD water and resell it through their own pipes.
Almost all of the supply comes from the Biscayne Aquifer, a porous limestone layer that sits just below the surface of South Florida. Because it is so shallow, it is recharged quickly by rain but is also more exposed to what happens on the land above it. A smaller share comes from the deeper, brackish Upper Floridan Aquifer, which feeds the Hialeah reverse osmosis plant serving Hialeah and the northwest county.
Most Miami homes get water from the “Main System,” WASD’s term for the combined output of three large plants: Alexander Orr Jr. (south of SW 8 Street), and John E. Preston and Hialeah (north of SW 8 Street). Orr and Hialeah use lime softening and filtration, Preston uses enhanced softening, and the two northern plants also air-strip volatile organic compounds. Chlorine is the primary disinfectant, then ammonia is added to form chloramine for the trip through the pipes. WASD stopped adding fluoride at these three plants on June 6, 2025, so fluoride is now only at natural levels of 0.1–0.3 ppm.
Miami water hardness
The 2025 report does not list a hardness number. It does say the main plants use lime to reduce hardness, which is why Miami water is gentler than the raw limestone aquifer water would be. Groundwater from limestone starts out hard, so softening at the plant takes much of the scale-forming calcium out before it reaches you.
Without a published figure, the honest advice is to test. A hardness test strip costs a few dollars and gives you a reading in grains per gallon (divide mg/L by 17.1 to convert). If you get more than about 7 gpg and see white crust on fixtures or shower glass, a softener or salt-free conditioner may be worth it; below that, it usually is not. Our guide to softeners versus filters walks through the choice.
What was detected in Miami tap water
These are WASD’s Main System results from the 2025 report, as published. The highest level for disinfection byproducts is the highest running average used for compliance, with individual samples in the range noted.
| Contaminant | Highest level | Legal limit (MCL) | Health goal (MCLG) | Typical source |
|---|---|---|---|---|
| PFOS | 33 ppt (range 7–33) | 4 ppt* | 0 | Industrial and consumer products |
| PFOA | 13 ppt (range 3–13) | 4 ppt* | 0 | Industrial and consumer products |
| PFHxS | 7 ppt (range 2–7) | 10 ppt* | 10 ppt | Industrial and consumer products |
| PFNA | 5 ppt (range ND–5) | 10 ppt* | 10 ppt | Industrial and consumer products |
| Total trihalomethanes | 50 ppb (range 9–59) | 80 ppb | none | Chlorination byproduct |
| Haloacetic acids | 34 ppb (range 10–43) | 60 ppb | none | Chlorination byproduct |
| Chloramines | 2.5 ppm (range ND–4.0) | 4 ppm (MRDL) | 4 ppm (MRDLG) | Disinfectant |
| Arsenic | 1 ppb | 10 ppb | 0 | Natural deposits |
| Nitrate (as N) | 0.3 ppm | 10 ppm | 10 ppm | Natural deposits, fertilizer |
| Uranium | 1 ppb | 30 ppb | 0 | Natural deposits |
| Combined radium | 1 pCi/L | 5 pCi/L | 0 | Natural deposits |
*The PFAS limits are new federal standards. WASD says initial compliance monitoring is underway and that PFAS violations will only be reported starting in 2029. EPA has also proposed changes to parts of the PFAS rule; our PFAS filter guide tracks where that stands.
Other detections included sodium at 33 ppm, fluoride up to 1 ppm early in the year, atrazine at 0.02 ppb and radon up to 86 pCi/L, which has no federal limit. Neither Cryptosporidium nor Giardia has been found in WASD’s source water.
Customers in the South Dade system saw similar PFAS (PFOS up to 32 ppt) and higher nitrate (up to 7 ppm, still under the 10 ppm limit).
Lead and copper in Miami
- Lead: 90th percentile 3.2 ppb in the Main System, with 1 of 102 homes above the 15 ppb action level.
- Copper: 90th percentile 0.07 ppm, with no homes above the 1.3 ppm action level.
Those are good results, but lead comes from household plumbing rather than the aquifer. WASD has published a service line inventory at miamidade.gov/knowyourpipes so you can look up your address. Homes built before the late 1980s are the ones most worth checking.
Violations
None reported. Every detected contaminant was below its MCL in 2025, and lead and copper were within action levels in all WASD systems.
Do you need a filter in Miami?
For most Miami households, PFAS is the main reason to filter.
- PFAS: choose a filter certified to NSF/ANSI 53 or 58 for PFOA and PFOS. An under-sink reverse osmosis system is the most thorough option for drinking and cooking water. Some certified pitcher filters also carry PFOA/PFOS claims.
- Chloramine taste: a whole-house catalytic carbon system made for chloramine helps every tap and the shower; see whole-house filters.
- Scale: test first, since the report gives no hardness value.
- Private well: Biscayne Aquifer wells are shallow, so test regularly; see our well water page.
Miami tap water FAQ
Is Miami tap water safe to drink?
WASD’s 2025 report states that all 22 detected parameters were below their maximum contaminant levels and lists no violations. PFOS (up to 33 ppt) and PFOA (up to 13 ppt) were above the new 4 ppt federal limits, which are not enforceable yet. Lead was low overall, but older homes should check their service line.
Does Miami tap water have PFAS?
Yes. The Main System’s 2025 results showed PFOS from 7 to 33 ppt, PFOA from 3 to 13 ppt, PFHxS up to 7 ppt and PFNA up to 5 ppt. Reverse osmosis and filters certified for PFOA/PFOS can reduce them.
Does Miami tap water have fluoride?
Not added anymore. WASD stopped adding fluoride at its three main plants on June 6, 2025, so Main System fluoride is now 0.1–0.3 ppm from natural sources.
These values change every year. All figures come from Miami-Dade Water and Sewer’s 2025 Water Quality Report.
Sources: Miami-Dade Water and Sewer Department, 2025 Water Quality Report; WASD water quality reports page.