Nashville Tap Water: What’s in It and the Best Filter

Disclosure: we may earn a commission from links on this page, at no cost to you. How we choose filters.

Nashville Tap Water: What's in It and the Best Filter: illustration of a city skyline with a water drop

Short answer: Nashville tap water met every federal and state drinking water standard in 2025, and Metro Water Services reported zero violations for the year. Nashville tap water comes from the Cumberland River, is disinfected with chlorine, and is moderately hard, so most homes don’t need a filter for safety, though a carbon filter improves taste and an older house may want lead-certified filtration.

Key takeaways

  • Metro Water Services (MWS) draws everything from the Cumberland River and treats it at two plants, K.R. Harrington and Omohundro.
  • The 2025 report lists zero violations; disinfection byproducts peaked at roughly half their legal limits.
  • Lead at the tap was low: the 90th percentile was 0.8 ppb, and none of the 85 homes tested reached the action level.
  • Hardness of about 100 mg/L (roughly 5.9 grains per gallon) is enough to leave some scale but rarely justifies a softener on its own.

Where Nashville tap water comes from

Every gallon MWS delivers starts in the Cumberland River. The utility runs two treatment plants: K.R. Harrington in Donelson, rated at up to 112 million gallons per day, and Omohundro, rated at up to 90 million gallons per day. Together they serve more than 226,500 water customer accounts across Nashville and Davidson County, according to the 2025 Consumer Confidence Report.

Because the source is a river, treatment focuses on removing sediment and microbes. Turbidity, a measure of cloudiness, stayed below 0.3 NTU in 99.9% of 2025 samples. For disinfection, MWS adds what the report calls “a small amount of bleach” (sodium hypochlorite). The utility’s history page notes it has generated that bleach on site since 2016, replacing the liquid chlorine it had used since 1920. That means Nashville uses free chlorine, not chloramine, which matters when you pick a filter: ordinary activated carbon handles chlorine well.

If your water bill comes from a different utility, its own annual report applies instead of this one.

Nashville water hardness

The report describes Nashville water as “moderately hard.” Its most recent hardness figures (from 2023 testing, which MWS carried into the 2025 report) show total hardness of 100.5 mg/L, with a range of 88.5 to 128.4 mg/L. Using the report’s own conversion (17.1 mg/L equals one grain per gallon), that’s about 5.9 grains per gallon on average and up to roughly 7.5 gpg.

At that level you may see white spots on glassware and slow scale buildup in kettles and water heaters, but it’s well short of the very hard water found in cities like Las Vegas or San Antonio. A whole-house softener is a comfort choice here rather than a necessity. If scale bothers you, our guide to softeners versus filters for hard water walks through the options.

What’s in Nashville tap water: 2025 results

These are the regulated contaminants MWS detected in 2025, copied from its report. Byproduct values are the highest locational running annual average.

ContaminantHighest levelLegal limit (MCL)Health goal (MCLG)Typical source
Total trihalomethanes (TTHM)43.5 ppb (range 13.4–65.5)80 ppbNone setChlorine reacting with organic matter in river water
Haloacetic acids (HAA5)27.8 ppb (range 7.8–36.0)60 ppbNone setByproduct of disinfection
Chlorine residual1.60 ppm (range 0.8–2.8)4 ppm (MRDL)4 ppm (MRDLG)Added to control microbes
Fluoride0.67 ppm (range 0.56–0.75)4 ppm4 ppmAdditive that promotes strong teeth
Nitrate0.362 ppm (range 0.336–0.392)10 ppm10 ppmFertilizer runoff
Turbidity0.56 NTU max; 99.9% of samples under 0.3 NTUTreatment technique (1 NTU)None setRiver sediment
E. coli0 positive samples00Human and animal waste

Sodium measured 12.20 ppm (range 11.7–12.9); there is no federal limit for sodium.

The figures that stand out are the disinfection byproducts. TTHM averaged 43.5 ppb at the worst location, about 54% of the limit, and individual results reached 65.5 ppb. That’s normal for chlorinated river water and not a violation, but it is the main thing a carbon filter would reduce.

PFAS in Nashville water

The 2025 report says MWS tested treated water for PFAS in 2015, 2019, 2021 and 2023 and found no reportable levels, with the November 2023 test non-detect. The utility’s separate PFAS page lists finished-water results of 1.0 ppt for both PFOA and PFOS, against federal limits of 4.0 ppt, and 0.4 ppt for PFHxS, PFNA and GenX. MWS says it meets the new standards. If you still want a margin, see what filter removes PFAS.

Lead and copper

Lead isn’t in the Cumberland River; it comes from service lines, solder and fixtures inside older buildings. MWS tested 85 homes in 2025:

  • Lead: 90th percentile 0.8 ppb, range under 0.10 to 7.1 ppb, 0 of 85 homes above the 15 ppb action level. The health goal is zero.
  • Copper: 90th percentile 0.130 ppm, range under 0.01 to 0.735 ppm, 0 of 85 homes above the 1.3 ppm action level.

Those are low numbers. Still, results vary house by house. MWS has built a service line inventory, checking records back to 1904, and publishes an interactive map, but the report doesn’t give a count of lead lines. If your home predates the late 1980s or the map shows an unknown line, run cold water before drinking and consider a filter certified for lead under NSF/ANSI 53.

Violations

None reported. The report’s headline reads “zero drinking water violations in 2025.”

Do you need a filter in Nashville?

Based on the 2025 data, a filter is about preference and older plumbing rather than fixing a compliance problem. Here’s how the findings map to filter types:

  • Chlorine taste and byproducts: A carbon pitcher or faucet filter certified to NSF/ANSI 42 handles taste; for TTHM, look for NSF/ANSI 53 VOC claims. See pitchers and shower filters.
  • Lead from old plumbing: Choose a pitcher, faucet or under-sink unit certified to NSF/ANSI 53 for lead. Our lead filter guide explains the claims.
  • Belt-and-braces drinking water: An under-sink or countertop reverse osmosis system cuts lead, PFAS, nitrate and fluoride, if you want to remove the added fluoride.
  • Whole-home chlorine and mild scale: A whole-house filter protects showers and appliances; pair it with a softener only if scale is a real nuisance.

Private wells in the county are a different story; if you’re on one, start with our well water hub.

FAQ

Is Nashville tap water safe to drink?

Metro Water Services reports that its water met all federal and state standards in 2025 with zero violations. Lead at the tap was low (90th percentile 0.8 ppb, no homes over the action level) and the utility says PFAS results meet the new federal limits. Homes with older plumbing may still want a lead-certified filter.

Where does Nashville get its water?

From the Cumberland River. Metro Water Services treats it at the K.R. Harrington and Omohundro plants, which can process up to 112 and 90 million gallons per day.

Does Nashville have hard water?

It’s moderately hard. The report lists total hardness of 100.5 mg/L on average (88.5 to 128.4 mg/L), which works out to roughly 5.9 grains per gallon. Expect some spotting and scale, but most homes don’t need a softener.

Sources

Sources: Metro Water Services, 2025 Consumer Confidence Report (data January–December 2025); MWS water quality page; MWS PFAS page; MWS water system history. Values change yearly; everything above comes from the utility’s 2025 report and pages, not from our own testing.